 |
 |
 |
|
The Strike Industries Slide Adapter Plate (SAP) allows you to use a GEN3 slide on a GEN4 frame. Naturally a GLOCK™ factory or aftermarket GEN3 slide will fit and function on a GEN4 frame, but there are a few issues to address. First is the ugly gap and the second is the flex in the frame because of the large hole. Install the SAP in seconds and prevent any movement of the GEN3 recoil rod and spring from possibly damaging your GLOCK™ GEN4. Because there is an abundance of aftermarket GEN3 slide options, Strike Industries wants to make sure you are not restricted by fitment and have your choice to fully customize your pistol. Giving you a cost-effective resolution with SI design, the Strike Industries Slide Adapter Plate won't hold you back on form and function.
Package Contents:
Product Features:
- Adapt GEN3 slide to GEN4 frame
- Prevent flex in frame
- Eliminate the gap
- Lightweight
DISCLAIMER: This product is not manufactured, authorized, endorsed,
or warranted by GLOCK. GLOCK does not warrant or represent that
this product is compatible with GLOCK pistols.
DISCLAIMER: “GLOCK” is a federally registered trademark of
GLOCK, Inc. and is one of many trademarks registered by GLOCK, Inc.
and GLOCK Ges.m.b.H. Neither Joe Bob Outfitters, LLC, nor this site
are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc.
or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to
advertise the sale of GLOCK pistols, parts, or components. For
additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and
parts visit www.glock.com.
⚠
WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and reproductive harm. For more information go to: www.P65Warnings.ca.gov.
|
|
|
 |
|
 |
|
