Two popular items in one convenient pack. A must-have for any Glock owner, this combo includes an 8-in-1 Pistol T-Tool and a Magazine Plate Disassembly Tool for Glocks, both proudly designed & manufactured in the U.S.
Pistol T-Tool:
Handles a variety of maintenance needs for your pistol all in one tool that easily fits in your pocket, range bag or pistol case. The base handle has four distinct purposes – 1/4” bit driver, 8-32 threaded insert to accommodate additional components, Memory-Flex® cable slot for use as a T-handle and punch hammer for resetting pins. The tool also includes four bits that seat in the magnetized bit driver. The pin punch has additional length to full push takedown pins through the frame. Keep from losing the nut on the front site with the magnetized front site adjustment tool. The tool also comes with one 5/32” flat head and one #0 Philips bits
- Essential maintenance tool for any Glock owner
- Easily fits in your pocket, range bag or pistol case
- 8-in-1 design
- ¼” bit driver is magnetized so bits don’t fall out
- 8-32 threaded insert for attaching additional components such as rods
- Slide a Memory-Flex® cable through the slot to use as a T-Handle when cleaning the bore
- Reset pins during reassembly with the punch hammer
- Longer length pin punch to fully push takedown pins through the frame
- Front site adjustment tool is magnetized for ease of installing front sight screw
- Also includes one 5/32” flat head and one #0 Philips bit
Magazine Plate Disassembly Tool for Glocks:
Safely and easily remove the magazine plate on Glock magazines for proper cleaning, maintenance and inspection. This tool removes the base plate in order to change out or replace springs. Works with standard Glock magazines and won’t damage the plate or magazine body. Not for use with Glock 30 round magazines or extended type base plates.
- Quickly and safely remove Glock magazine plates, allowing for proper cleaning, maintenance and inspection
- Change out mag plates or replace springs
- Works with standard Glock magazines
- Will not damage plate magazine or body
- Not for use with Glock 30 round magazines or extended type base plates
- Quickly and safely remove Glock magazine plates, allowing for proper cleaning, maintenance and inspection
- Change out mag plates or replace springs
- Works with standard Glock magazines
- Will not damage plate magazine or body
- Not for use with Glock 30 round magazines or extended type base plates
Instructions for Use:
- Holding magazine body with one hand, insert post into the hole at the bottom of the magazine base plate with the other hand.
- Place thumb on top of magazine base plate to capture spring. Keep magazine pointed in a safe direction at all times.
- Rotate wrist down. Make sure your thumb stops the magazine spring from launching out of the magazine body. Continue to push the base plate off the magazine body.
