|
THE best bang for your buck to improve any AR15 Trigger!
One of the BEST upgrades possible for a mil-spec fire control group, period! This trigger adjuster replaces the factory grip screw to reduce trigger creep, lessen pull weight, and improve hammer break for better accuracy. Use alone or as part of a complete trigger job. Use this to fine-tune any mil-spec style trigger. These can be used in combination with the KVP Reduced Power Trigger Springs to take the pre-travel out of a trigger and reduce the trigger pull weight.
SPECS: Steel Grip Screw manufactured in the USA
Steel Set Screw manufactured in the USA
Grip screw is Swiss CNC machined to accept the internal adjustment set screw.
Gunsmith fitting recommended but not required.
Included in package:
**(1) Internally Threaded Grip Screw with Trigger Adjuster Set Screw Installed **(1) Star Washer **(1) 5/64 Hex Key for install
Directions for Assembly:
***BE SURE THE FIREARM IS
UNLOADED BEFORE PROCEEDING***
- Separate the upper receiver from the lower receiver.
- Cock the hammer
back and set the safety lever to safe.
THE LOWER MUST BE ON "SAFE" TO ADJUST CORRECTLY.
- Completely remove
the set screw from the adjuster by turning the Allen Key
CLOCKWISE.
- Apply Blue Loctite
to the set screw.
- Re-Install set
screw to original position with hex head.
- Remove original
grip screw.
Make sure not to lose the
safety spring & detent!
- Place adjuster
into grip and tighten thoroughly with a 3/16" Hex Driver
- Tighten set screw
using 5/64 Hex Key. Do
not tighten past stopping point.
- At this point the
safety lever won't move or will be hard to move.
Leave on safe.
- Back the set
screw out 1/8 turn at a time until the safety lever moves freely again.
- Function test the
lower checking that hammer, trigger, and safety are all functioning correctly.
This is as far as you can adjust the
adjuster.
Let the loctite dry
overnight.
These directions
are intended to aid a qualified gunsmith in installation.
The lower receiver must be drilled and tapped all the way through the pistol grip or the trigger adjuster will not be able to thread in completely. Please inspect your lower receiver prior to installation to ensure safe installation.
⚠
WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and reproductive harm. For more information go to: www.P65Warnings.ca.gov.
|
|
|